Ante Supe
Member
2022 Intense Sniper XC, Size XL: Asking $1,700
Currently 120mm travel Front & Rear.
Sniper XC Carbon Frame with 165 x 45mm Fox Float Factory DPS shock (Linear compression tune for 120mm travel).
- 12 x 148 Boost bolt-on rear thru axle.
- BBinfinite PF92 bottom bracket + Race Face Next SL crank arms + Wolftooth CAMO Spider.
- Fox Factory Transfer 100mm dropper post (no remote lever).
Fox Factory 34 Step-Cast Fork 120mm + Kabolt 15 x 110 Boost bolt-on thru axle.
- 9point8 Slacker Kit + Cane Creek 40 headset + carbon headset spacers + OneUp Components EDC threaded top cap. (I'll include tool for removal of Slacker kit)
Extras:
- Take-off from new 165 x 40mm Fox Float Factory DPS shock (Digressive compression tune for 100mm travel).
- New complete top and bottom links with new bearings.
- Cane Creek 40 top cap and star nut.
- 2 take-off from new bottle cages.
Side notes:
- BB bearings are well worn, but don't make noise. Will need to replaced relatively soon.
- Pivot bearing are also worn but quiet, but you get new ones included!
- Partial Ride Wrap protection, not in perfect condition, but it did it's job.
- Cushy chain slap protection, super quiet!
- Fork steerer is threaded for OneUp EDC, plenty of length (I ran 40mm stack under the stem), that may well get cut off if you prefer lower bar height.
Currently 120mm travel Front & Rear.
Sniper XC Carbon Frame with 165 x 45mm Fox Float Factory DPS shock (Linear compression tune for 120mm travel).
- 12 x 148 Boost bolt-on rear thru axle.
- BBinfinite PF92 bottom bracket + Race Face Next SL crank arms + Wolftooth CAMO Spider.
- Fox Factory Transfer 100mm dropper post (no remote lever).
Fox Factory 34 Step-Cast Fork 120mm + Kabolt 15 x 110 Boost bolt-on thru axle.
- 9point8 Slacker Kit + Cane Creek 40 headset + carbon headset spacers + OneUp Components EDC threaded top cap. (I'll include tool for removal of Slacker kit)
Extras:
- Take-off from new 165 x 40mm Fox Float Factory DPS shock (Digressive compression tune for 100mm travel).
- New complete top and bottom links with new bearings.
- Cane Creek 40 top cap and star nut.
- 2 take-off from new bottle cages.
Side notes:
- BB bearings are well worn, but don't make noise. Will need to replaced relatively soon.
- Pivot bearing are also worn but quiet, but you get new ones included!
- Partial Ride Wrap protection, not in perfect condition, but it did it's job.
- Cushy chain slap protection, super quiet!
- Fork steerer is threaded for OneUp EDC, plenty of length (I ran 40mm stack under the stem), that may well get cut off if you prefer lower bar height.
