Eagle AXS RD adjusting or resetting

[Pampa]

I installed a used Eagle AXS RD, which was working fine until I took it off from the previous bike, on a new bike with an Eagle 1295 cassette and somehow, it's badly out of whack. It reaches the largest cog with one more shift to go and there's ghost shift, double shifting and no shifting up and down. I tried adjusting the H and L screws and the B screw too but nothing changes really (the problems areas shift a little). I noticed that on each shift the RD light blinks red instead of green but using the AXS app I don't get any error message or indication of what's going on or what to do. I also noticed that when I use micro-adjust on one cog and get it to work, the same offset vale is applied to all the other gears. This wasn't the case last time used the micro-adjust (you could set different values for each cog or pairs of cogs - I think). I applied the latest firmware to both the shifter and the RD. Any ideas on how to adjust or reset the RD?

 

[Steve Vai]

I installed a used Eagle AXS RD, which was working fine until I took it off from the previous bike, on a new bike with an Eagle 1295 cassette and somehow, it's badly out of whack. It reaches the largest cog with one more shift to go and there's ghost shift, double shifting and no shifting up and down. I tried adjusting the H and L screws and the B screw too but nothing changes really (the problems areas shift a little). I noticed that on each shift the RD light blinks red instead of green but using the AXS app I don't get any error message or indication of what's going on or what to do. I also noticed that when I use micro-adjust on one cog and get it to work, the same offset vale is applied to all the other gears. This wasn't the case last time used the micro-adjust (you could set different values for each cog or pairs of cogs - I think). I applied the latest firmware to both the shifter and the RD. Any ideas on how to adjust or reset the RD?

Micro adjust applies to all cogs, since the very beginning of AXS. More than likely the gearing is one off. Look on the app and confirm the number at the top is the actual cog the RD is in. If not, adjust the micro until it is.

 

[Pampa]

OK. Will try that. Got a rare day of snow here. Not too much but enough to call it a maiden voyage for my new fatty 🙂