free GMAT printer watch mold builder

[THATmanMANNY]

yes, you read that right GMAT study guide to be a professional printer watch mold builder

Needs troubleshooting. “Says can not clean 50”. Connects to PC fine and gets final to print. Then that msg comes up. A YouTubed a little but gave up after 5min
-Brother multi function printer with cable MFC-685CW, print, scan, FAX! Low ink

-2015 three GMAT study guides, the test format isn't the same now but the questions are still relevant

-Timex Ironman Bodylink watch, gps, HR. Everything probably need batteries. This is like 10+ years old. I have no idea if the tech is still supported but the watch is fine if you replace the batteries

-new sealed Mold builder, I was told you can mix your own stans with this using windshield fluid. Have not tried.

 

[GSTim]

@Patrick for the Mold builder, I know he mixes his own.

 

[THATmanMANNY]

 

[Patrick]

@Patrick for the Mold builder, I know he mixes his own.

i buy it by the gallon - and use RV antifreeze rather than ww fluid.

 

[onetracker]

i buy it by the gallon - and use RV antifreeze rather than ww fluid.

What is your recipe if you do not mind sharing? Does your homemade hooch work as well as Stans?

 

[Patrick]

What is your recipe if you do not mind sharing? Does your homemade hooch work as well as Stans?

50/50 liquid latex and rv antifreeze. This was @rick81721's brew.

Got the latex from an online costume/make-up source for $50/gal, RV antifreeze is $6, so two gallons for $56.
Works great. There is no grit in it, and i've been thinking of a little 000 sand. @michael.su likes to add some
slime sealant for the grit to help plug holes.

It did seal this hole after another minute of letting it set up.